RAM

Home / RAM

We Service and Repair all RAM cars

  • 2015 RAM 3500 HD

    RAM 3500 HD
    Mileage
    29,340
    Service Date
    6/12/2026
    Services Performed
    • Scanned vehicle found several codes P0871- OD pressure switch rationality P0988 4C Pressure switch rationality P2509 ECM/PCM Power input signal intermittent U3017 Control module timer/ clock performance P1776 Solenoid switch valve latched in L/R position Cleared codes and road tested vehicle. Found that the transmision drives ok but there is a shudder on the 2-3 shift on light throttle. Codes did not return after first drive. Fluid level full but color looked ok fluid smelled burnt. Recommend pulling pan and valve body to bench test valve body and transmission. Pulled the pan and inspected, found some normal material in the transmission pan but nothing abnormal. Tested valve body and found that the switching valve is not holding vacuum. Should vacuum test between 15-18 InHg current test 0-1 InHg. Air tested transmission and found hydraulic side OK at this time but the burnt fluid smell more noticeable. Suspect internal transmission damage with a failed valve body Disassembled valve body and found the switch bore was not reamed correctly. Recommend transmission rebuild with valve body replacement.
    • TRANSMISSION ASSEMBLY – Removal & Installation – R2500,R3500,4WD,Trans Mfr CD 68RFE
    • TRANSMISSION ASSEMBLY – Overhaul Removed – R2500,R3500 – [Includes: Perform Relearn procedure.] – [Includes: Inspect and replace all necessary components, reassemble and adjust.]
    • Shipping-parts
    • Shipping
    • Valve body
     
    NICK B. gave our service a 5 star review on 6/14/2026
  • 2015 RAM 3500 HD

    RAM 3500 HD
    Mileage
    29,340
    Service Date
    6/12/2026
    Services Performed
    • Scanned vehicle found several codes P0871- OD pressure switch rationality P0988 4C Pressure switch rationality P2509 ECM/PCM Power input signal intermittent U3017 Control module timer/ clock performance P1776 Solenoid switch valve latched in L/R position Cleared codes and road tested vehicle. Found that the transmision drives ok but there is a shudder on the 2-3 shift on light throttle. Codes did not return after first drive. Fluid level full but color looked ok fluid smelled burnt. Recommend pulling pan and valve body to bench test valve body and transmission. Pulled the pan and inspected, found some normal material in the transmission pan but nothing abnormal. Tested valve body and found that the switching valve is not holding vacuum. Should vacuum test between 15-18 InHg current test 0-1 InHg. Air tested transmission and found hydraulic side OK at this time but the burnt fluid smell more noticeable. Suspect internal transmission damage with a failed valve body Disassembled valve body and found the switch bore was not reamed correctly. Recommend transmission rebuild with valve body replacement.
    • TRANSMISSION ASSEMBLY – Removal & Installation – R2500,R3500,4WD,Trans Mfr CD 68RFE
    • TRANSMISSION ASSEMBLY – Overhaul Removed – R2500,R3500 – [Includes: Perform Relearn procedure.] – [Includes: Inspect and replace all necessary components, reassemble and adjust.]
    • Shipping-parts
    • Shipping
    • Valve body
     
    NICK B. gave our service a 5 star review on 6/14/2026
  • 2016 RAM 3500 HD

    RAM 3500 HD
    Mileage
    50,025
    Service Date
    2/4/2026
    Services Performed
    • EXHAUST MANIFOLD – Remove & Replace – In-Line6 – [Includes: R&I Turbocharger. Includes: R&I EGR Cooler Assembly.]
    • Shipping & Handling
    • HEADSTUDS – Install
    • Shipping & Handling
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
    • REAR SWAY BAR – Install
    • Shipping & Handling
     
    EARL P. gave our service a 5 star review on 2/5/2026
  • 2011 RAM Pickup

    RAM Pickup
    Mileage
    101,088
    Service Date
    1/23/2026
    Services Performed
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
    • Test drive vehicle. Inspect for leaks. Remove pan (if possible) from transmission. Replace and/or clean filter/screen. Adjust bands as necessary, if possible. Re install pan with new gasket and fill with proper fluid. Check level and check for leaks.
    • REPLACE MARKER LIGHT
     
    STATON B. gave our service a 5 star review on 2/4/2026
  • 2015 RAM 1500

    RAM 1500
    Mileage
    99,008
    Service Date
    12/22/2025
    Services Performed
    • Checked for diagnostic trouble codes, found one: P0087 – Fuel Rail Pressure Too Low – Bank 1 Monitored rail pressure while cranking, commanded is 5200psi, was only producing 510psi, then suddenly the rail pressure shot up to commanded and vehicle started. Ran for 10 minutes then died again and wouldn't restart. Same symptoms as before. Checked fuel pressure from supply pump, slowly ramped up to 45psi and engine started, with running was only producing 35psi. Specification is 58-85psi. Recommend replacing supply pump and fuel filter and retesting high pressure pump.
    • FUEL FILTER – Remove & Replace – V6,3.0L Eng Chassis Mounted,Fuel/Water Separator Element
    • FUEL PUMP – Remove & Replace – V6,3.0L Eng In Tank,w/Skid Plate
    • WATER PUMP – Remove & Replace – V6,3.0L Eng – [DOES NOT include Air Conditioning System charge, if necessary add Air Conditioning System – charge (complete).]
    • AIR CONDITIONING SYSTEM – Complete Charge – R-134a Refrigerant – [Includes: Air Conditioning system recover, evacuate and recharge.]
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
     
    JEFF H. gave our service a 5 star review on 1/7/2026
  • 2021 RAM 3500 HD

    RAM 3500 HD
    Mileage
    41,620
    Service Date
    10/31/2025
    Services Performed
    • Test drive vehicle. Inspect for leaks. Remove pan (if possible) from transmission. Replace and/or clean filter/screen. Adjust bands as necessary, if possible. Re install pan with new gasket and fill with proper fluid. Check level and check for leaks.
     
    SAMUEL E. gave our service a 5 star review on 11/5/2025
  • 2019 RAM 3500 HD

    RAM 3500 HD
    Mileage
    105,362
    Service Date
    8/22/2025
    Services Performed
    • Test drive vehicle. Inspect for leaks. Remove pan (if possible) from transmission. Replace and/or clean filter/screen. Adjust bands as necessary, if possible. Re install pan with new gasket and fill with proper fluid. Check level and check for leaks.
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
    • FUEL FILTER – Remove & Replace – 6.7L Eng Chassis Mounted,Element
    • FUEL FILTER – Remove & Replace – 6.7L Eng Engine Mounted,Element
    • CRANKCASE VENT FILTER – Remove & Replace – In-Line6
     
    RUSS P. gave our service a 5 star review on 9/19/2025
  • 2020 RAM 3500 HD

    RAM 3500 HD
    Mileage
    83,820
    Service Date
    6/18/2025
    Services Performed
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
     
    MIKE H. gave our service a 5 star review on 6/18/2025
  • 2016 RAM 3500 HD

    RAM 3500 HD
    Mileage
    38,983
    Service Date
    2/7/2025
    Services Performed
    • INTAKE MANIFOLD GASKET – Remove & Replace – In-Line6 Cover &/or Gasket
    • INTERCOOLER – Remove & Replace – In-Line6 Air – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
    • Shipping & Handling
    • Remove and replace automatic transmission filter and gasket. Added fresh transmission fluid. Inspect for leaks. Road test vehicle.(Some vehicles are equipped with a washable transmission filter and/or a reusable pan gasket)
    • Remove cover. Remove old gasket material, drain old fluid, inspect internals and reassemble with new gasket. Install new fluid to proper levels. Road test vehicle for proper operation.
     
    EARL P. gave our service a 5 star review on 2/8/2025
  • 2013 RAM 2500 HD

    RAM 2500 HD
    Mileage
    132,190
    Service Date
    10/22/2024
    Services Performed
    • Confirmed head gasket failure. Engine failed block check quickly after warm up.
    • TRANSMISSION ASSEMBLY – Removal & Installation – Trans Mfr CD 68RFE,In-Line6,4WD
    • (Additional) – TRANSMISSION ASSEMBLY – Removal & Installation w/Two Piece Driveline add
    • (Combination) – FLYWHEEL – Remove & Install or Remove & Replace
     
    MIKE H. gave our service a 5 star review on 10/22/2024